****Installation of any aftermarket Map Sensor will require a custom ECU Calibration to ensure the ECU reads the sensor's accurately after installation.****
The long awaited Lesitune 5 Bar Map Sensors are here!!!
Four pin connector.
Integrated IAT sensor.
Leistune 5 Bar Map Sensors
These sensors were designed with the limits of the factory Bosch MED 17.1.1 4.0t ECU in mind.
There is a coded software limit from Bosch that will only allow the ECU to read up to 5120hpa, or 5 Bar.
No matter what hardware comes out moving forward, you will have plenty of overhead with your map sensors.
They have been tested on the bench down to 250hpa, or .25 Bar, or 25KPA, or 3.26psi depending on your preferred flavor of measurement. In theory can read lower, however, the testing equipment could not physically pull a lower vacuum.
The sensors were tested up to…
5000hpa/5.0 Bar/500kpa/72.5psi. absolute.
AKA 58PSI OF BOOST!!!!
AKA 4.0 Bar… of BOOST!!!
Packaged up nice and tidy in an OEM style housing.
SENSOR SCALING INFORMATION:
.5 - 4.5V
0-5000HPA
0-5Bar
0-500KPA
0-58psi
Gradient: 1250 (625 for the Dynospectrum flashing utility)
Offset: -625
